![brocade san switch cli change ip address brocade san switch cli change ip address](https://i.ytimg.com/vi/9S7LrXA9z4c/hqdefault.jpg)
- BROCADE SAN SWITCH CLI CHANGE IP ADDRESS HOW TO
- BROCADE SAN SWITCH CLI CHANGE IP ADDRESS SOFTWARE
- BROCADE SAN SWITCH CLI CHANGE IP ADDRESS SERIES
The WAN link (if you are not familiar with it), is usually a long distance link between two routers. The two sites are connected via a WAN link. Refer to the hardware installation guide for your specific product.I was involved for a project for one of our customers that involved configuring remote replication between two Sun 6180 storage boxes, one located in Cairo and the other located in Port Said (which is 200km away). The 10/100/1000 Ethernet management port (mgmt0) is connected to an external hub, switch, or router.The console port is physically connected to a computer terminal (or terminal server).Step 1 Verify the following physical connections for the new Cisco MDS 9000 Family switch (see Figure 2-4): To configure the switch, follow these steps: The switch setup utility helps you configure the switch. Use a modular, RJ-45, straight-through UTP cable to connect the MGMT 10/100/1000 Ethernet port to an Ethernet switch port or hub. You can use this port to access and manage the switch by IP address, such as through Cisco Fabric Manager. The Supervisor-2 module supports an autosensing MGMT 10/100/1000 Ethernet port (labeled "MGMT 10/100/1000") and has an RJ-45 interface.
![brocade san switch cli change ip address brocade san switch cli change ip address](https://docs.bmc.com/docs/discovery/contentref/files/997880650/997880670/1/1527174385006/BNA_Install_1.png)
Use modular, RJ-45 cables to connect the 10/100 Ethernet management port to external hubs and switches.
BROCADE SAN SWITCH CLI CHANGE IP ADDRESS SOFTWARE
If only the active supervisor module is connected to the LAN and an event occurs that causes a system switchover (such as a software upgrade), the switch becomes unmanageable through the Ethernet port after the active supervisor reboots and the standby supervisor becomes the active supervisor. Tip The two Ethernet connections should be connected to ports in different slots on the same LAN switch, or should be split between two different LAN switches.
![brocade san switch cli change ip address brocade san switch cli change ip address](https://halid.org/content/images/size/w2000/2018/09/Brocade-6520-Switch.jpg)
BROCADE SAN SWITCH CLI CHANGE IP ADDRESS SERIES
BROCADE SAN SWITCH CLI CHANGE IP ADDRESS HOW TO
This section describes how to connect the RS-232 console port to a PC. Subnet mask for the switch's management interface.IP address for the switch's management interface.Switch name-This is also used as your switch prompt.Distance limitations for each signal typeīefore installing the device, have all additional external equipment and cables available.īefore you configure a switch in the Cisco MDS 9000 Family for the first time, make sure you have the following information:.Cabling required for each interface type.When preparing your site for network connections to the Andiamo 9500 switch, consider the following for each type of interface: Connecting to the MGMT 10/100/1000 Ethernet Port.Connecting the 10/100 Ethernet Management Port.This chapter includes the following sections: This chapter provides instructions for setting up the hardware, connecting to the console port, and initially configuring the switch. Connecting the 10/100 Ethernet Management PortĬonnecting to the MGMT 10/100/1000 Ethernet Port